TOPIC: trying to add plumbing to my utility section

I added plumbing to my utility section with main water line, main water line valve, supply lines, vent and waste lines, septic, water well and water pressure as sub headings. My problem is when I down load a pic or a comment to one sub heading it shows up on all the sub headings and when I generate the report the pic and comment show up in the rest of the sub headings. How do I add new sub headings, damage and selection panels to the new plumbing section and not have this issue?  ???

Hi Aaron,

First, what version of the program are you using (look under About->About)?

Note, the tab names are not what appears in the report. It's the damage panel names. What did you call all the damage panel and selection panels? Did you give them all the same name? Post a PDF here so I can see what's going on.

Here is the file Dominic. I am using version H.I.P. v2.6.6.8

aaronshomeinspections.com/reports&fileNa...ector=Wyo.+Jackolope

Did you make a copy of tabs within each the plumbing section? This shouldn't be possible on 2.6.6.8 but you could have done it in an earlier version. If so the internal name would be the same which can mess things up. Try going to Edit Template and make a copy of the entire Plumbing section, then see if you have the same issue in the new page.

Aaron

Could you post a copy of your template.

In the plumbing section where the photo is repeated 4X I see duplicate headings of materials with crawl space and electrical panel in areas that is for the plumbing.  Some thing is not right.

Sounds like tabs were copied within the same section, but I thought we had completely eliminated the possibility of that in 2.6.6.8 which means it was done previously or we missed something.

Like David said, a copy of your template would be helpful as well.