TOPIC: New Mobile item ungray item

Every once in a while I find the need to go off my normal routine to add in an item.  So I head to that area, say Electrical / GFCI.  Make a notation / photo and back out.  The item goes gray as if it is finished, but it it nowhere near complete.  I would like to see a way to "un-gray" an item so it does not show as complete.

Hmm, if you ungray it manually, what would gray it again?

I guess it could continue to gray each time you enter data in that area, just an option to manually un-gray for errors or needing additional information from a later time in the inspection.

example.  While walking outside before clients arrive, you note an outdoor GFCI that is charred and broken.  So you enter the info.  But you haven't checked the kitchen, bath, garage, laundry or dishwasher gfci's.  Would like the option to keep "ungrayed" until I know I am done.

Or simpler....  my fat finger hits the wrong damn section and it grays out and I haven't inspected that area yet.  (most likely)    >