TOPIC: I might be slow, but getting there.

Marcel, you need to get the html code fon the Nachi site. I don't remember if you get that from your account page or the free logo page.
Once you get the code, log into your site, select "Blocks" from the admin menu, at the top of the blocks page you will see a tab that says "new" or "add new" and select it. You will need to name the block, (i think mine is nachi seal) and go to the page editor. In the page editor you will se a tab that says "source" select it and paste the html code in the editor. You can then save the block and you will find it in the list if blocks that show up on the page you will be directed to.

You can then use the drop down menus to select the position of the block in your left sidebar (if I remember correctly). At the top of the block list the ones you are currently using are listed with their "weight" position shown. You can use these as a guide for setting the weight of your new block.

Do not forget to scroll down to the bottom of the page and select "Save Blocks" before leaving the page.

Thanks Drew, I'll give that a try.

Well, found add new block, that is as far as I went.
Page editor is as far as I went, could not find that so I escaped.  ;D

Marcel,

Go to the Website Tutorials section of the message boards here and look at the NACHI Call Now Button Tutorial. It's EXACTLY the same except you're using the verification code rather than the call now code.

Thanks, I'll try that. 

Well, I am not getting there at all.

Click to verify becomes nothing but what I pasted as a code that is shown in the left column.

What the hell am I doing wrong.
Damn, this is frustrating.

Blocks
Click on add Blocks
Paste code in block and save
assign region
saved

No logo just code